Suspension
Kits & Frames :: Pics
of Components included with Suspension Kit :: Assembly
Guide
The
pictures below are not a complete assembly guide for
installing your suspension kit - this only includes
the key steps for assembly to use as a reference - view
the full
assembly instructions here. |
Assembly
Pictures for Outdoor/Indoor Suspension Kit |
|
| Create
a loop with the cable to prepare for attaching to the
turnbuckle. |
|
| The
cable is looped through the eye of the turnbuckle. |
|
| After
looping the cable through the turnbuckle eye (shown above),
remove the nuts from a cable clamp, and place the "U-shaped"
section over the cable, and re-secure the bolts for a
tight fit. (The extra cable extending outside of the cable
clamp should be taped off to prevent fraying or injury.) |
|
| The
Turnbuckle is hooked to the Eyebolt, which is drilled
into your wall or frame structure. |
|
| Close-up
of snap-ring, wire cable, & cable clamp. (The extra
cable extending outside of the cable clamp should be taped
off to prevent fraying or injury.) |
|
Full
view of all components assembled in proper order.
From
left to right: The black plastic snap-ring is attached
to the cable and the BORDER ROPE of your net (attached
direct to mesh in picture); the cable is looped through
the turnbuckle and secured with the cable clamp; the
turnbuckle is connected to the eyebolt, which is screwed
into a pre-drilled hole in your wall or frame structure.
(The extra cable extending outside of the cable clamp
should be taped off to prevent fraying or injury.) |
|
| The
turnbuckle is tightened to increase tension in the cable
line, which reduces sag in your net. |
